Harness Cable for Bosch Seat Motor

Assembly Required.
The Bosch Seat Motor DIO kit comes with all the additional parts needed to connect the Bosch Seat Motor and Harness Cable (am-3564) to the robo-RIO DIO, providing usable feedback. 

Check out the downloads tab for a full assembly guide. 

Warning! 
The adhesive inside the shrink tube permanently seals the electronics. Please test your circuit and confirm operation before using the provided shrink tube!

Specifications: 

• Length: 1.9 in
• Width : 0.6 in
• Height: 0.4 in
• Weight: 0.0115 lbs

Individual Components within this Bundle:

• 1 x 180 Ohmn Resistor
• 1 x 220 Ohmn Resistor
• 1 x 5.6k Ohm Resistor
• 1 x Adhesive Shrink Tube
• 2 x PNP Transistors
• 1 x Female Connector
• 1 x PCB

This is an adapter to convert the female spline output of the Bosch Seat Motor (am-3493) to a 2 inch long 0.5 inch hex shaft. The square end interfaces with the female spline of the motor and is retained by an included 6-32 screw and washer. Our testing shows that in a back-drive situation the worm gear in the gearbox will fail before the motor spline or this adapter. 

Specifications: 

• Overall Length: 3.014 in.
• Hex Length: 2.0 in.
• Hex Width: 0.5 in.
• Square Width: 0.23 in.
• Weight: 0.126 Pounds
• Material: 4140 Steel

Included Hardware:

• 1 - 6-32 x 0.5 in. Hex Head Machine Screw - (Sold in a Bulk Qty as am-1436)
• 1 - #6 x 0.375" OD Flat Washer