This is the cable designed for the encoder that is pre-attached to the NeveRest Series of motors and gearmotors. It has a connector on the opposite end to directly interface with the REV Expansion Hub or the REV Control Hub.
2019 Update:
The 'a' version of this cable as the encoder channels swapped so that the encoder counts in the same direction as the output shaft spins. This simplifies the usage of the encoder with the various programming languages for FTC!
This is an encoder cable used to provide power and receive encoder signals from a Hall Effect Two Channel Encoder and break out each connection to a single pin perfect for a 2.54 mm pitch. This encoder is provided on our RS775 motor, which is on our PG Gearmotors as well as the NeveRest motor, which is on these Gearmotors:
It has a common white connector on the end addressing the encoder and four individual female connections to fit into the input connector on a robot controller.
May be used with 6mm D-Shape Shaft to secure wheels in their position.
Specifications:
Used to change motor to axle motion 90 degrees. This can be used in between the U-channel.
This 20 Amp fuse is used in FIRST Tech Challenge batteries and the FIRST Robotics Competition Power Distribution Panel (am-2856). Specifications:
The NeveRest 60 is a gearmotor with an attached encoder. The output shaft geometry and the gearbox housing diameter is similar to what FTC teams are familiar with. The shaft is a 6 mm D and the gearbox housing is 37 mm diameter.
Use this 10-cell, 12-volt rechargeable pack to bring long-lasting power to TETRIX® motors and electronics. This 3,000 mAh NiMH pack features a built-in, 20-amp replaceable fuse for safety.
(THIS BATTERY IS FTC LEGAL)
TETRIX MAX Motor Shaft Hubs attaches wheels and gears to motor shafts. Each hub comes with a screw and is made of heavy-duty aluminum.